Blueberry Cables

Equipment:

Needles size 4

9 skeins of PT2 yarn, or Ullteppegarn from Gjestal

Tapestry needle for weaving in ends and seaming under the arms

Methods:

Knit and purl

Raglan

Decrease and increase

Gauge:

37 rows x 20 stitches = 10x10 cm (4x4 inches)

How to:

The sweater part:

Cast on 216 stitches.

Knit 2, purl 2 until it measures 8 cm (3.2 inches)

Then start cable pattern: Knit 2, purl 2, knit 6, purl 2, knit 2, purl 2.

Knit 3 rounds of this, then on the fourth round, when you come to the ”knit 6”, slip 3 stitches onto the cable needle and place this behind your main needles. Then knit the next 3 stitches, and finally knit the 3 stitches on the cable needle.

Complete 10 rounds before doing another cable twist.

Measure to see if you have the desired lenght by holding it tightly under your arm and let it hang down. On the picture this piece measu

res 64 cm (25.2 inches).

When you reach desired lenght, place a marker at beginning of round, and a marker half way through (at the 108th stitch). Begin the round by binding off 4 stitches, then continue the round. Four stitches before the next marker, you start binding off 8 stitches. Countinue the round, and bind off the last 4 stitches. Take care to see the cables are centered, meaning an equal amount of cables on each side of the midline in front before binding off stitches.

The sleeves:

Cast on 60 stitches.

Knit 2 and purl 2 around and around until it measures 12 cm (4.7 inches). Then make an increase at the beginning and end of each fourth round until total lenght measures 24 cm (9.4 inches).

Bind off the first 4 and last 4 stitches of the round, keeping the rest on the needles.

Logically, you make 2 of these.

Putting it together:

Place each sleeve onto the needle with the rest of the sweater – one in each ”bind off section”. Take care to place the bind off section of the sweater and sleeve opposite eachother.

Then place a marker at each sweater and sleeve junction – a total of 4 marker. The marker at the beginning of each round should have a different color than the other three to help you recognize when a new round starts.

On every second round, you knit 2 together, knit 1 before each marker, then knit 1 and knit 2 together before each marker.

Continue cable pattern from the sweater part, and the knit 2 purl 2 from the sleeve part.

Continue until you have 160 stitches left on you needles.

The collar

The collar is made by knit 2 purl 2 throughout the round.

Continue 15 rounds.

Keep a marker at the beginning of each round and halfway through each round. 1 stitch before each marker, you increase 2 stitches. Do the same 1 stitch after each marker. Take care to maintain the knit 2, purl 2-pattern in the front and at the back of the collar, keeping the increases on the sides.

Collar is finished when you feel it is large enough. On the picture I made a total of 4 round of increases.

Bind off loosely.

Weave in ends, and seam the holes under the arms. Enjoy!